Total closure wiring
 

Hi, anyone fitted a total closure unit on a 2000 Sigma alarm

Think i have instructions for pin to feed module, but what wires are used on to connect to windows / relay & where is the relay for the windows?

Many Thanks

Generally in drivers door for drivers window and loom from drivers door for rest of car

Ian

Excellent, thanks for the info

Cheers

Edit, think sorted Cheers :D

All sorted & working :D

Fancy posting a diagram up :-)

Hi Mate no wiring diagram as such but here goes

Used a Toad total closure unit PW 402

Comes with instructions,
Red to permananent live, soldered behind under dash fuse box
Earth
Signal wire, connected this to pin 3 on the alarm ECU, pins have a diagram of the numbering scheme on the control box, this pin becomes an earth when the alarm is armed.

Then the difficult part , needed to get 4 wires into the drivers door, would be 8 on a 4 door!

Followed the route of the factory alarm through the door gromets.

Need to find the wire that feeds the live on the up stroke of each window, then cut in 2 a few inches from the window switch & connect wires from Toad module as per instructions

Hope this helps?

Nothinf like telling people your alarm and how you wired it in. Dont trust the forums on security tbh

Nice one fella, been wanting to do this for a while but never got around to it.

Cheers for the time :-)

Gary

This was window closure not alarm :sleep:

You only need to get 2 wires inside the door, the others are in the drivers kick panel.

Gary, if you need a hand, give me a shout, I'm near the trafford centre and have done a 'few' of these :thumb: