1993 Wrx Quick Shift Fitment?
 

Hi

Ive just brought a wrx and the linkage is the worsest thing ever lol, just wondering if any one has a guide to fitting one of these just to make it abit better for now till i can get a proper one.

http://cgi.ebay.co.uk/NEW-Quick-Shif...item5185972ffc

any help/advise would be great as i can only manage to find a guide to fit to 1997 onwards at the moment

i not got 1 but reading this im thankful as i was going to buy 1. doesnt it come with fitting guide

takes about 30mins to fit got one on mine best thing i ever did tightens the gearchange no end

The one he has is nacked, not the one he is enquiring about:)

how much was yours mate. my gearchange is all over place.

cheers guys.

another thing it is currenty sloppy as hell, could this be sumthing else wrong, before i fit this shifter?

If the toothed nylon type bush that holds the shifter is worn yes it would be sloppy. Also if the linkage attachment to the shifter isn't tight it would be sloppier. I took mine apart today, quite funny that this thread came up. I was considering changing but it looks as good as new I'm sticking with OEM rather than step into the unknown.

im guessing u have to get to the bush with the car on the ramp as it cant be done from inside?

was it eay to do mate. can u give us a roug guide on how u checked up on it

Inside job, from what I could see. Remove the lower dash fascia to get to the shifter, remove holding plate, weather gasket and you can see your driveway:D The shifter sits in a little tealight shaped holder held in by a snap ring, uncouple the bolt that holds the shifter to the transmission, remove snap ring and then pull out shifter, from what I could see.

http://www.youtube.com/watch?v=VrDlrxcn7dk

Pretty much:thumb::)

thanks for that mate. i will check up on mine as it dont feel too good

Edited, snap ring, easy peasy ! hope you feel better.:thumb:

this is the type you want, none that ebay tat.

http://cgi.ebay.co.uk/Subaru-impreza...item2a0555e9ee

congrats on bringing an impreza, welcome.

V3+ though.:confused:

got one fitted to my v1 no problems this end

i was wondering if there is anything i can do to make the shifter tighter before i take it apart or am i best getting new bushes etc