heater blower from under glove box 1999 ( facelift dash )
 

my heaters are not blowing any air out and have noticed that the 2 solder joint in the inside of the circuit board under the cover have melted lol , i dont have to hand a soldering iron and dont want to solder it back together as it melted of for a reason and dont want it happening again :(

was looking for 1 about £20 as this is what my mate eddie payed for his from scooby spares and if u could post a pic it would be better as at least i know it would be the right one :)

car is a version 5 sti with facelift dash btw :)

forgot to mention its only the fan and circuit board part that comes of with the 3 big screws that i need , the bit that is labeled BLOWER MOTOR down below :)

THIS IS NOT AN IMPREZA BLOWER BUT YOU GET THE DRIFT JUST THE PART THAT IS LABELED BLOWER MOTOR AND FROM UNDERNEATH THE GLOVE BOX ITS HELD ON WITH 3 SCREWS AND JUST UNCLIP THE CABLE FROM IT .
http://fixautopartz.com/wp-content/u...ic-diagram.png

Crap, I have just sold the motor itself from mine. :(

I have the plastic though, if yours is cracked. :)

Also have the centre section (the white part next to the blower plastic),
if interested. :)

Cheers,

R.

no mate sorry :) its just the circular blower fan with the flat circuit board and motor built into it from a version 4/5

i will have one of those,i have just broke a my99 and the all the heater system is still in the shell.pm me if interested.