Car pulling to the Left?
Hi all,
My car has pulled to the left slightly since i got it 12 months ago. I had the tracking done etc after changeing the rear bolts to camber bolts etc and it still did it slightly. Today I swapped front to rear wheels etc and now its a lot worse. Any ideas? |
Sticking Brake caliper perhaps? Or if you are running on Bridgestone tyres you maybe getting tramlining from the tyres.
|
it only seems worse above say 30 mph. They are bridgestone but no matter what the road surface, pull hard to the left. Its worse now the backs are on the front that have a lot more tread?
|
might be tyre pressures slightly diffrent as i had that with my classic even with a full geo set up done
|
Any idea the best PSI for all four?
|
i normally just put 32 psi all round tbh . i noticed my new bugeye was all over the road and pulled to the left . i checked mine and the passenger front was on 25 psi . set them all to 32 and seems fine now
|
will try it tomorrow. I tried on the motorway services but gauge was rubbish. Passanger one was 15 and drivers 23 ish so did them to what looked like 30 thinking I found it, it made it worse lol
|
How much tred is left on the tyres. I had the same prob with my REO70s when they got a bit low
|
Front ones have loads on now, i would say above 4mm
|
Have you had a full geo set up ? that might be the way to go. as said before tho make sure you have the correct tyre pressures and even wear on all four tyres.
|
Probably is the tyres doing it
|
Mine had about 3-3.5 when they were doing it but mine waz tram lineing all over the place pulled to the right when I put my foot down and to the left when I let off. I changed the tyres it waz fine.
|
I had a full geo set up, 3 times to ensure correct lol.
The fronts where bad wear on outer edges before geo setup so have just moved them to rear and rears that where ok, 4mm etc no edge wear, to the front. |
Originally Posted by the_big_1
(Post 9236103)
I had a full geo set up, 3 times to ensure correct lol.
The fronts where bad wear on outer edges before geo setup so have just moved them to rear and rears that where ok, 4mm etc no edge wear, to the front. |
I was hopeing moveing the fronts to the rears would stop it pulling after the geo setup but made it worse. Not sure if the tyres are just fubard but I dont want to replace them all if the old rears are ok or nacker new ones.
|
All times are GMT +1. The time now is 04:07 AM. |
© 2024 MH Sub I, LLC dba Internet Brands