bottem end help video added
just baught a wrx import on a n reg belive that the bottem end has gone how much is that likley to cost to fix or am i better to replace the engine thanks
|
Bang a newage bottom end in there simples
|
okay thn shall look into that gotta check it is the bottom end thats gone on this 1 as i havnt checked it yet its rather nocky wen u rev it after a recent service
|
£2-3k to get garage to rebuild, cheaper of course if you can do it yourself ;) If going with 2nd hand engine be careful where you buy it from :(
TX. |
The cheapest option would be a doner engine for a couple of hundred quid. The only problem will be you cannot guarentee the condition it's in.
If you can afford to spent around £2000 on an engine rebuild then that would be the best option, but is it worth spending that kind of money on a 14 year old cad unless your planning on mega power in the long run. |
Check the crank pulley first. It might be that it's not as tight as it should be
|
hmmm okay im thinkin about puttin my engine out my l reg wrx in it as thats fine and the body work on the l reg 1 is **** and needs a full respray
|
video of the engine dunno if any1 can tell from this http://vidmg.photobucket.com/albums/...player=offsite
|
Hi I got some bits off here being told was for newage as my bottom end went. Didn't end up using them as Paul from zen performance discovered they were from a classic so I got done.
So I now Have ACL race bearings, rods, oil pump and a crank if any help. £200 |
I have a low mileage WR1 shortblock 22000 miles £1100
|
any1
|
Sounds like the bearings away to me
|
All times are GMT +1. The time now is 09:51 AM. |
© 2024 MH Sub I, LLC dba Internet Brands