Boost Pressure Question [V5 STI]
Hi All,
Just a quick question really. What is the standard Boost pressure in PSI That a 1999 V5 Sti Should be running? Mine is running a Blitz induction cone, Roger Clarke Decat Downpipe (3" -> 2.5"), Maganex Center (2.5") And Standard STI Back Box. Was getting 8/9psi boost before the Decat, Still getting about 9psi boost, but with a boost creep of 2psi to 11PSI Is this the right boost pressures? If not, What do you think might be the cause? I look forward to the replys! Cheers Peter |
|
Hmmm, So going by that Chart I should be running 16PSI . . . .
Where is my lost PSI!! |
As standard it should be running 1.1bar which equates to about 16psi.
Banny |
running that boost i dare say the brass pill is missing or you have a direct pipe to the actuator. cheers max
|
Been On The Phone To Jollygreenmonster.co.uk
Excellent help and advise, suggested the Brass Restrictor pill was in the wrong place, or missing. Had a look, and there it was, Sat on the Actuator side of the T-piece!!!. Swapped pipe so pill was between compressor housing and T-piece. Back to 16psi 1.1 Bar of boost as I should have been running. All I can Say is WOW!, Mega difference. Thankyou very much jollygreenmonster.co.uk! Any a thanks to Max as well, as noticed you have given me same advice after they did!. Case Closed. Cheers Peter |
Got a similar issue on mine, believe the restrictor pill is missing in total, where can you get these from? :)
|
either make them from solid rod/studding etc and drill small hole in middle depending on boost wanting to run. Or main stealer i guess. cheers max
|
Main dealer supply them, I think they are a stock item too?
|
Originally Posted by damandblast
(Post 8794971)
Got a similar issue on mine, believe the restrictor pill is missing in total, where can you get these from? :)
If you wan't to get one from a dealer the Part No is: 22326KA120 Phil |
Originally Posted by Barretts Motorsport
(Post 8795275)
If you wan't to get one from a dealer the Part No is: 22326KA120
Phil Cheers Jay |
no mate it goes in the small 6mm tube of the blower you need a 0.9mm one others are 1.2mm and other varied sizes. cheers max
|
All times are GMT +1. The time now is 11:03 AM. |
© 2024 MH Sub I, LLC dba Internet Brands