clifford concept 50, valet switch
 

Does anyone have one fitted to there car or know abit about them?

My problem is the three wires on the back of the switch have broken off and I am not 100% sure were they go on the switch pins, I can resolder the wires back on if i knew which goes where, the wire colours are red, white and black.
I have tried the local car radio shops but nobody has them anymore.
Does anyone have any ideas?
Thanks.

Have you looked on the clifford website for an installation manual?

yes but it only has the manual i got with the alarm which shows you how to use it and the only other wiring diagram i could find shows the wires going to the switch but not the pins the should go to.

ring this number between 10.00am and 16.00 02085705005 it is called smk they deal with clifford the actual fitter who is a close friend is away but they might help if no luck then if you can wait a week then email me

Try this...

Clifford Electronics (DEI) - Concept 50 Wiring Diagram on PDF-Zoo.com

without actually seeing another switch your not going to find any info on it. im not even sure those switches are still available.

Rikky- thanks for that mate, I will try them tomorrow.

Boro- I have to pay for that download so i may try that last. Thanks for your help

CSE- I think that may well be the only way to sort it and no they don't sell the switches anymore with the loom attached, i can buy the switch but i then have the same problem.

im back at work tomorrow so i will have a look and see if i have one kicking around. i usually keep stuff like that.. you never know when it might come in handy :)

Thanks I will keep my fingers crossed. :thumb:

Thanks all, i have it sorted now.
If anyone else needs it, the wire connections at the switch are:

RED = latch side of switch.
WHITE = Centre pin.
BLACK = spring loaded side of switch.

There is another way of doing this with no switch, press clifford clifford then either boot release button or the other one next to it ( was on my old car so i cant quite remember ) sends it into vallet mode till you re arm the car, if its not boot release button it silences the alarm when arming so just do it again to re enable audio chirp

handy tip, thanks :thumb: