Inlet manifold spacers / header tank spacers
as above!
Manifold needs to come off again, would be handy if anyone had a set of these for the P1? PM me or ring / text 07740336145 |
btt
|
|
Thanks mate, Carl Davey will be an option, but was hoping someone might have some on here somewhere for cheaper?
|
btt
|
btt
|
Make your own,i did. Cost £15 for the tufnol,enough to make two sets,and the header tank spacers.As long as you have an abro file it's quite easy!
|
Originally Posted by mit
(Post 8083281)
Make your own,i did. Cost £15 for the tufnol,enough to make two sets,and the header tank spacers.As long as you have an abro file it's quite easy!
Also whats a abro file lol |
Hi, i purcahssed the 10mm sheet from Engineering Plastics, Nylon, Acetal, PTFE, Tufnol Rod & Sheet.
An abro file is a saw blade which is like a very fine file,so can saw in any direction,allowing corners to be delt with easy! I drew round the inlet gasket on the sheet,cut it out with the abro file,then finished off smoothing it out with the dremel. hears one of the finished articles! http://i284.photobucket.com/albums/l...arparts056.jpg |
All times are GMT +1. The time now is 11:59 AM. |
© 2024 MH Sub I, LLC dba Internet Brands