Perrin Crank Pulley
 

Just fitted one of these to my sti2 and its wobbling and hitting the casing behind it. Its fitted properly, is this just an unbalanced pulley? Anyone else with similar problems? Purchased it from tsl.:wonder:

Are you really sure it's fitted correctly, bought mine from ebay and it works a treat.

Just curious how much did you pay for yours?

if its wobbling and hitting things then its not on proper, take it off and do it again. should be a very tight fit over the shaft.

Make sure its located on the keyway on the snout of the crank and done up
fu*king tight (127Nm).

Mick

Cheers for replys, going to refit it over the weekend and see how we go. Its only wobbling slighty, only noticable from the side. It was a display model so thought maybe it had tacken a knock at some point perhaps?

Has to be fitted incorrectly. I hope you havent tightened it fully with the keyway not in place as it may have screwed the crank.

I would take it to an expert to make sure if you are unsure.