Fitting side graphics
 

Is there any special way of fitting or special tools needed



cheers Alun

Bit of water with a couple of drops of washing up liquid in a trigger spray bottle, a plastic spreader and a scalpel.

and a hair dryer

if you have never done them before dont even think about putting them on dry

Did all mine, full car in 1 hour and never done it before, but you will need 2 people, to do anything big,.

Done mine too just take your time:thumb:

I did my previous scoob in full rally graphics by myself, would prob be best with 2 people tho as would be quicker rubbing out the air bubbles, i took a few hours to do it as id never done it before, if your nervous about doing it use lots of soapy water so it wont stick for a while and you have plenty of time to move the pgraphics around on your car into the exact position you want, but donw forget the more soapy water you use the longer you need to leave it to dry.

good luck and as already said just take your time, the end result will be worth it :D

Dave

:thumb: :thumb: :thumb: :thumb: :thumb:
cheers all