connecting boost gauge
 

can anyone point me in the right direction as to were to connect the pipe from my boost gauge on a bug eye engine cheers thanks chris

boost take off
 

the take off for boost gauge is on top of inlet manifold,it has a rubber bung on it.hope that helps:thumb:

As far as I know you have two alternatives. One is to tee into the vacum hose on the top of your dump valve.
I T-ed into the hose at the manifold as per the pic below. The only thing I did differently from the pic was to attach a short piece of hose to the manifold connection and attach the T piece to that. This allows you to go back to standard easily if required.
There is no rubber bung on a bugeye engine. That only applies to Classics I think.

http://i16.photobucket.com/albums/b4...8102007016.jpg

thanks :thumb:

Any vac hose or blanked port thats on the inlet manifold,as all your reading is manifold pressure ....