ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   Wanted (https://www.scoobynet.com/wanted-18/)
-   -   various little bits for a 1999 impreza & advice (https://www.scoobynet.com/wanted-18/654000-various-little-bits-for-a-1999-impreza-and-advice.html)

weapon 15 December 2007 06:44 PM

various little bits for a 1999 impreza & advice
 
have repaired a damaged sti 5 and am short of some minor parts to finish off. steering cowels, drivers side airbag impact module bracket- the bracket that bolts to front chassis leg- just the bracket needed not the module thing, sti rear lights, charcoal filter bracket only, centre bonnet rubber- clips to front edge of bonnet, drivers side radiator to front panel bracket- must have the extra bit on for cars with power steering cooler pipes, lastly i need the plastic guards that go under the front of each corner of the bumper and join up to the wheel arch liners. and also some technical advice- there is a pipe under the car on the chassis rail roughly under the passy seat, i have the other pieces of pipe but unsure of where they go and what they do- not seen these before its 18 months since i stripped the car. your help is much appreciated, please just get back to me with price on bits. thanks matt

scoobymoz 15 December 2007 07:00 PM

you have pm mate :thumb:

is your car a wagon or saloon? as i have a set of wagon STI rear lights.

weapon 16 December 2007 09:43 AM

car is a saloon

scobymad 16 December 2007 10:46 AM

hi mate

Got a complete set of splash guards for the front the bit that runs under the arch and the bit that runs under the bumper dont mind splitting if you want them posted out but if you wanna collect you can take the lot make me an offer and there yours

http://i84.photobucket.com/albums/k3...8/S8001239.jpg

let me know:thumb:

bowsaaa 16 December 2007 10:50 AM

Think I might have a few of those brackets your after, as for the pipe your stuck on I think you'll find its the breather/vent from the bottom of the carbon canister, it should run from the can, between the rocker & chassis, behind the sub-frame then mine splits into 2 with 1 line running down each chassis rail to a small vent box.


All times are GMT +1. The time now is 08:28 AM.


© 2024 MH Sub I, LLC dba Internet Brands