polar performance chip in sti
what sort of gains would i get if i put a polar chip in my ecu,
i have a sti v2 it has ported manifold decat 3" race exhaust 2.5" walbro fuel pump k&n induction kit it running a 7k ecu and i get 1.1 bar now ,the injectors are standard and so is the intercooler at the moment |
if it's running 1.1bar now then it's probably already been chiiped, wither in the UK or Japan.
The 7K is only mapped to run 0.9bar. |
there is no chip in there ,there is a socket for one ,
i was hoping that you would reply scott, ive adjusted the actuator arm on the turbo a bit i dont know if that would do anything it should be about 275-280 standard ,what would your chip add to that and would it give it more torque matt |
STi 2 tend to be up around the 300BHP - 310BHP mark on a 1.1bar map.
The actuator may of helped increase the boost a touch but it may be more of a spike to 1.1bar rather then holding. |
scott thanks for your help
ive fitted a chip from hamyam who had bought a subachip off of your self ,it came of a sti ra 1995 ,ive reset the ecu after fitting and im getting fuel cut at moment so im going to adjust the actuator arm to see if that helps thanks matt |
If you had already adjusted the actuator prior to fitting the chip, then thats probably the best thing to do.
If ever I adjust an actuator I always set it so the it's 1/2 lined up on the pin i.e you have to tug it a little to drop on (but not so much so that it's really short/over tightened). |
have set the hole so its 1mm away ,so the arm has to be pulled the 1mm ,getting fuel cut every now and then, but when i floor it and the boost comes in it is in a on off spluttery way and back fires . something needs adjusting ,its smooth off boost, then the boost comes in and i dont no what is going to happen
any help would be great matt |
Sounds like coil pack failure, probably induced by the increased boost and the safer fuel/timing setup.
What is it boosting too now, as it may still be fuel-cutting. |
took all coil packs out to inspect 1 split rubber and two broken plastic ends ,so glued and wrapped tight with tape and went for spin,started of slow just incase but seemed ok when given some biscuit,
will now adjust the actuator arm to get full boost thank for help if it starts to splutter or miss ill have to get some new coil packs matt |
ive got sum coil packs goin cheap if you after sum they are two pin ones pm me if interested
|
Nice one......you wouldn't believe the number of people that don't believe me when I say coil packs and think it's the map in the chip.
However, all have to eat humble pie when they 'eventually' decide to change them. |
as i said it was runnig well but only getting 0.9,so the next step was to turn the actuator arm half a turn at the time to up the boost ,took for a spin felt much more mid range but then the dreaded cutt out, floored it up the hill and wow then into third and firth were i could only get 0.7 and no more
going to turn the arm back today see what nappens then,if nothing has changed will have to get some new coil packs, but why am i still not getting 1.1 on the boost gauge |
All times are GMT +1. The time now is 07:01 AM. |
© 2024 MH Sub I, LLC dba Internet Brands