removing air vent surrounds.
 

am looking at removing and spraying the air vent surrounds etc in my scoob. do these come off easily or is it a bummer to do? also looking to remove the door handle surrounds.

anybody any ideas?

cheers :thumb:

Classic or later model?

If Classic, passenger and driver vents pull out of dash panel.

Centre vents - couple of screws near to the three knobs and dials - then the whole section comes out (a few wires connected so don't pull too hard).

Very straightforward if you have a bit of patience.

its a classic wrx :thumb:

I will post a few pictures tomorrow as I have just replaced the heater panel colours on my classic.

Pictures say a thousand words!

Richard

that will be ace cheers :thumb:

Releasing driver's side vent:

IMG_0603.jpg - Image - Photobucket - Video and Image Hosting

IMG_0604.jpg - Image - Photobucket - Video and Image Hosting

Screw location to release centre vent:

IMG_0606.jpg - Image - Photobucket - Video and Image Hosting

<cough>

Your piccies aren't there.... Unless you've cunningly hidden them somehow.

they were there earlier coz i saw them but they gawn nows :thumb:

Sorry Mate - I managed to delete (Doh)

Will repost.

Centre vents (location of screws):

IMG_0620.jpg - Image - Photobucket - Video and Image Hosting

Side vents (just pull them out):

IMG_0619.jpg - Image - Photobucket - Video and Image Hosting

thats a great help, have now had a practice go at taking all the vents off and am going to spray them metallic silver soon. will post up the final results :thumb:

o.k guys,how do the actual movable parts of the vent come out,as i wanted to fit my knocklink in there
cheers