What do I need to run more boost
I am swapping from an Apexi ecu and an Apexi boost controller to a Simtek ecu that uses the standard map senser. Before I was running just under 1.4 bar, am I right in saying the standard map senser will only go to 1.25.
What do I need to be able to run the boost as before, car is 93 type RA. |
No one??
|
are you looking to sell ur apexi ecu?
|
standard map sensor on Pre96 only allows you to run about 1.15bar boost with fuel cut set at 1.25bar (approx).
you may be able to run with a Post96 Map sensor if the simtek can be rescaled with the required values/cal data. Is the simtek available to anyone to fit now ? or is it limitted to Harvey/Steve Simpson ? |
SimTek can be configured to run any MAP sensor.Favourites would be 97-98 Subaru or Delco 3 bar.Your installer can advise.
Dealers currently are: Interpro, Bristol Alan Jeffery Engineering, Plymouth Triton, Bournemouth ScoobyMania, Nottingham Simpson motorsport, Lancaster Steve |
I was told 50quid + VAT for a higher rated MAP sensor to go with the Simtek.
Dave :) |
Originally Posted by scooby350bhp
(Post 7096784)
are you looking to sell ur apexi ecu?
|
Originally Posted by Scott.T@PolarPerformance
(Post 7096808)
standard map sensor on Pre96 only allows you to run about 1.15bar boost with fuel cut set at 1.25bar (approx).
you may be able to run with a Post96 Map sensor if the simtek can be rescaled with the required values/cal data. Is the simtek available to anyone to fit now ? or is it limitted to Harvey/Steve Simpson ? Just steve I think. |
Read Post#5........
|
All times are GMT +1. The time now is 04:25 PM. |
© 2024 MH Sub I, LLC dba Internet Brands