apexi boost control pipes
 

Hi got a power fc with the additional boost controller,which pipe goes to which on the solinoid valve as in com,on etc.Also do you need to keep the original map sensor conected?
Many thanks Rob

COM to Actuator, NO to compressor cover.. NC then works as a vent.

You don't have to keep the original map sensor connected no.. however if you have the AVC-R (not clear from your post) then the original map sensor is good for monitoring boost etc.. although only up to 1.23bar where it tops out.

The boost control need switching over to the new one within the map.

Simon