Dump Valve Fitting
I have searched the forum but not been able to find fitting instructins for my dump valve. All I need to know is where to fit the small vacuum hose to? I'm fitting a Bailey Atmospheric one so I know I need to block up the old hole, just can't work out where to fit the small 4mm Vacuum pipe to! My car is a JDM MY96 with the coil pack located in the centre of the inlet manifold. Any pics would be great. I bought it second hand but I never got a 'T' piece do I need to plum it into an existing pipe?
Any help much appreciated. Thank You,:thumb: Jamie |
You'll need a "T-Piece" mate, T into the hose that goes to the wastgate actuator:)
|
Ok not to sure where abouts that is, is there only the one hose going to the actuator? Just got a pic from Lee who I bought it off he had it plumbed straight into the top of the inlet manifold!!! There seems to be hoses all over the place there!!! Very confusing! :confused:
|
Did you have a recirc dv on your intercooler before? I fitted my bailey dv yesterday in 10 mins. Any of the small pipes on the inlet manifold or the actuator one will do the job.
|
mines the earlier model with the pipe coming off the intercooler so I guess its just the same. I'll go get myself a t - piece from Halfords today and get it installed!
cheers Jamie |
Robbieben have you had any running problems or peformance loss since fitting your dump valve?
|
All times are GMT +1. The time now is 10:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands