H&R spings wrx MY55
 

Dont know if anyone can help but here goes!! I fitted -50mm H&R springs to my MY98 Impreza sport a couple of years ago and was amazed by the difference in handling (coupled with turbo alloys+GSD3's). I've now also got a MY55 WRX 4dr and it disappoints me in the cornering department ie, roll SO been thinking of doing the same with the H&R springs again and wondered if anyone has done the same ??? Any feedback appreciated or even pictures!!

-50mm sounds far too low to me. :D

If it's roll that concerns you, then fit some uprated antiroll bars.
a 55 plate will work well with 22mm front and rear.


Andy

Sounds like good advice. Would we be talking Whiteline upgraded bars, front and back???

Yes 22mm whiteline front and rear bars.

Andy

I fitted the H&R -50mm on my MY00 classic.... in reality it dropped the car 25-30mm against the standard turbo ride height.

Thanks Andy

Checked out all the posts regarding Whiteline ARBs. I've ordered front and rear with droplinks. Will report back once fitted.