ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   Heat Management (https://www.scoobynet.com/general-technical-10/529106-heat-management.html)

Eprom 11 July 2006 05:35 PM

Heat Management
 
Hi
I have just purchased a down pipe with a high flow cat, are there any problems with heat wrapping these pipes? Don’t want to overheat the cat if that’s possible, but want to keep the under bonnet temps down.
Car is MY99 with ported headers Harvey up pipe and panel filter, using PPP ECU.

Jolly Green Monster 12 July 2006 10:51 AM

wrap the top section of it to keep heat out of the engine bay but not the cat..

imho
Simon

Eprom 12 July 2006 11:22 AM


Originally Posted by Jolly Green Monster
wrap the top section of it to keep heat out of the engine bay but not the cat..

imho
Simon

Thanks Simon

I was not sure if the Cat would take the heat if the whole pipe was wrapped, I just want to keep the under bonnet temps down as much as possible, had a thought of wrapping all the pipe but leave the cat unwrapped.

I will now just wrap the the top section.


All times are GMT +1. The time now is 12:23 AM.


© 2024 MH Sub I, LLC dba Internet Brands