Knock link sensor question?
Do you remove and replace the OE sensor with the Knock one supplied or do you blt the new one on top?
Thanks Ricey |
leave the existing one where it is as ecu still needs this, bolt the new one on seperately (normally near the RH intercooler bracket)
|
OK cheers Mark.
Is their a specific place on the block for it? Ricey |
there is a bolt hole above the starter motor on top of the engine that is ideal. It takes iirc a M8 bolt (may be an M6) Probably needs to be about an inch and a half in length. You should be able to get access without removing the intercooler using a long extension bar and suitable bit. (may be a bit fiddly connecting the sensor connector though)
|
|
Best replys I have had in ages!! :-)
Thanks, I should have said I have a 2001 Bugeye, so I take it thay are all the same. Ricey |
All times are GMT +1. The time now is 02:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands