Mazda 6 Sunroof Close Clifford
 

Looking for some assistance!

Details:
Mazda 6 Sunroof has two switches (open/close) and vent (open/close)
- from the information I have the switch is directed wired to the motor and the vent wire changes polarity based upon where the roof is.


Clifford Concept 600 - has a window close circuit
violet - motor +
white/violet - switch +
white/orange - switch 2+
orange - motor 2+

I believe aux C - Gray/Red is the output that also comes into play.

Now what is happening is this:
When sunroof is opened, upon arming the sunroof will close then vent - NOT GOOD! I don't need two way function.

We were able to do this with a Civic, but it was a one switch for open, close and vent - WE HAD TO PROVIDE CONSTANT POWER TO THE ROOF, so with the key out you could still operate the sunroof.

I've searched the forums, and have seen a few creative ideas, but nothing consistent. I had thought about a mag switch to determine if the window is closed then cut the trigger, but I don't have the experience necessary to pull it off.

Anyone has any ideas to wire up this circuit to make it work?

I Appreciate it!

Mike

Only thing I can tell you without seeing it and what wires are what is that the wires you listed are not part of the alarm, it will be a separate sunroof closer, and aux c is the channel used to activate it, other than that dont know mate, sorry.