another steering wheel thread MY95
 

i have a new wheel to replace the nardi one that is currently on, and am relacing the hub and putting on a new one and a snap off kit. i cant get the 6 torque screws out as i dont have the right tools basicly, i removed the larger nut on the thread behind and was hopeing that i would be able to remove the full thing in one, but i am unsure if its just realy tight and have to just pull hard, or i have to do sumit else to get it off. any ideas?

Ok, Ive got a tip... put the big nut back on 1or2 turns...Then yank on the wheel till it comes off.. it will be tight.
By leaving the nut on, you wont end up smacking yourself in the face...now undo the nut..job done.
Hope this helps.

Willy

well so far it aint going very well. i aint got the right torque screw to get the actual wheel off but that wouldnt matter if i could pull the whole thing off in one go, unfortunatly i cant do that either. its so tight i cant even move it 0.1mm (trust me i measured it!) i have been putting some stuff on to try and rot the lock tight or whatever has been put on it, but pulling, hitting, shouting and screamigng at it wont budge it at all. its so irritating having my new wheel and snap off kit in the house and not being able to use them

........:D .......TELL US WHAT 'APPENED ........did you take the bus instead ..:p

there getting drilled on fri night..... just incase it takes more than 1 night to sort it witch im sure it will, coz even if i get it off then snap off kit i think is gonna need a few adjustments to make it fit right.


i'll keep u posted