ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   Drivetrain (https://www.scoobynet.com/drivetrain-11/)
-   -   ??any ideas?? (https://www.scoobynet.com/drivetrain-11/354874-any-ideas.html)

rb5037 20 August 2004 09:50 AM

??any ideas??
 
RB5 MY99

Due a service, booked for a couple of weeks time.

Clutch does need replacing.

Question.

Noticed when driving the car on Sunday there's a vibration coming from the engine area that i can feel through the steering wheel.

It's only when i'm in a gear pulling away.

Any gear when pulling away i can feel the vibration, foot off the gas and it stops, put the clutch down and it stops, free wheel in neutral with clutch up and i can't notice it.

The gearbox oil is fine.

Engine oil was a bit low 2 weeks ago so i topped it up. now it's a bit high but been that high before.

Any ideas??

Thanks Adam

rb5037 21 August 2004 09:11 PM

Guess you all have no idea!!!

Could it be a drive shaft? Think it might be the drivers side one.

Aztec Performance Ltd 21 August 2004 09:16 PM

Flywheel judder?...try this...slowly press the clutch pedal in bit by bit(with engine on)...if you feel a vibration on the pedal its defo the flywheel.

Bob

rb5037 21 August 2004 10:29 PM

Only feel the vibration when in gear and speeding up.

Can now hear a scrapping noise, more when turning wheel right slightly.

Think it could be a drive shaft.

How much ££££ should i be looking to spend getting it done at a subaru garage?

Adam

Gidney&Knowlesy 22 August 2004 09:55 AM

About £825 all in for new flywheel, clutch kit & fitting..........(Genuine Subaru parts of course)

rb5037 22 August 2004 06:28 PM

When i asked the question on how much? i ment for a new drive shaft.

Now that clutches have been brought up, what and how much for a good one i.e. a high performance low slip heavy duty. Cars producing 286 bhp.

Thanks Adam

rb5037 26 August 2004 10:49 AM


Originally Posted by rb5037
When i asked the question on how much? i ment for a new drive shaft.

Now that clutches have been brought up, what and how much for a good one i.e. a high performance low slip heavy duty. Cars producing 286 bhp.

Thanks Adam

BTTT

dazdavies 27 August 2004 11:37 AM

AP racing Organic


All times are GMT +1. The time now is 12:18 AM.


© 2024 MH Sub I, LLC dba Internet Brands