ORCIARI Fog covers fitting advice
Has anyone got the Orciari fog light covers fitted ??
Check this out http://bbs.scoobynet.co.uk/showthread.php?t=325986 I'm looking for some advice on the fitting and it's very very quite in the styling section these days :rolleyes: Thanks Simon :D |
Bump.......
I was hoping to do a trial fit today before spraying, anyone got em ??? or an opinion ?? Thanks Simon :D |
why dont you just fit them the way the instructions tell you to?
|
Micky.. yes I know mate but it says to drill the bumper for the metal clips to fit in.... I would prefer not to drill as if I decide to remove them at any stage you would see these slots drilled in... and it does not matter how carefull you are you can never make a factory finished job of the drilling because of the angle and location of the holes.
I was thinking that a couple of blobs of silicon sealer where the clips are would be enough to secure them in that area ? and was wondering if anyone else has actually drilled or not. I guess it's like MFI you buy the cuboards and throw the instructions in the bin before you start to assemble :rolleyes: But I take you point mate, just looking for maybe a better option here than the drill... and with a silver car any holes will show up more than if it was darl in colour. Thanks Simon |
if you glued them and then they fell out you would be more then gutted
drill them and use a file to make sure the holes are nice and "slot-ish" if you wanted to remove them it would be nothing to fill the slots back in and do a smart repair due to there location it would be barely noticeble, if it all |
Thanks Micky
I'll get a small peice of plastic and do a few trial slots first, as you know its more a run of holes joined together rather than one on its own, I'll post a few pics when fitted. Simon :) |
All times are GMT +1. The time now is 09:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands