tom tom + ipaq
 

I have tom tom on my ipaq which is fine, i also have the speed cameras on, the problem is i have the bmp camera icon but cannot get it into the poi or on the map,the box is crossed and it says speed cameras but no icon,can you help as i'm going mad.

Thanks in advance
Steve

What software are u using to display the POIs? I use Checkpoint which is available from www.pocketgps.co.uk.

camera icon
 

It is checkpoint that we are using with tt2 but the icon has not come up:(

Steve

Have you had a look at the instructions on the pocketgps site? I followed these and it all worked OK. Have you got the bitmap image in the correct folder? Make sure you run the Checkpoint software which should then automatically run Tom Tom.

Si.

si, I should be getting my dell pda next week, can you come over one night and show me how to set it up?
cheers,
chris.

Chris, no problem just let me know when. What kit other than the Dell have you gone for?

Steve, any luck with the speed cameras?

Not at all
 

It picks them up ok and the audiable warning sounds but no icon's, i have put the icon in the GB maps on the storage card, also tried to copy into POI, so still no luck.

Steve

Steve, I don't know if you have seen this link http://www.pocketgps.co.uk/uksafetyc...checkpoint.php it is the full guide to installing the cameras. I have used Checkpoint V2.0.2 as there have been problems with the latest version. If you are getting the camera warnings and sounds but no camera bitmaps in Tom Tom I can only think you do not have the pocketgps option turned on in Tom Tom Properties under the POI section. Can't be much more help I am afraid.

Si.

tt2
 

Thanks for your help Si I will have a look at the link and go thru everything again.

Cheers
Steve