Can anyone help


I have just received an Intercooler water switch from Graham Goode. Gonna fit it at the weekend as already got the rest of kit fitted i.e Spray Nozzles and resorvour tank etc

Can Anyone tell me which connectors I need to use to use for switching purposes??

Any help appreciated

Graham Goode did fax the circuit diagram over but it isnt much help Just need to know which pins are positve and negative pics would be appreciated greatly!!

for a manual switch
pin 1= manual trigger
pin 2= illumination
pin 3= ground
pin 6= illumination

for pressure
pin 1= ignition on input
pin 2= illumination
pin 4= power out to circuit
pin 5= ground
pin 6= illumination


hope this make some sence to you because it does`nt with me. i aquired a full wiring diagram for a diy i/c water spay kit but have`nt tried it. these are what was on it
regards mike

spot on mate have you sussed it cheers mate