Do the pre 97 ecus allow you to remap using a 3 bar map sensor? I know that the atmospheric pressure would be out a little, but is there a way to do it?
I am thinking that that if you want over 17psi mapped, you need to get a Link ecu. Paul |
When I compared the voltages, in johns fuel cut defencer thread they were way out.. Does the solenoid change make any difference as well?? as the newer one has a three port boost solenoid...
Can we not just adjust the map sensor scaling value in the ecu as discussed?? David |
Voltage for Pre97 MAP Sensor are (Best Viewed in EDIT mode):
kPa mmHg PSI Bar mv -26.7 -200 -3.87 -0.267 2100 -21.36 -160 -3.096 -0.2136 2200 -16.02 -120 -2.322 -0.1602 2300 -10.68 -80 -1.548 -0.1068 2400 -5.34 -40 -0.774 -0.0534 2500 0 0 0 0 2600 5.34 40 0.774 0.0534 2700 10.68 80 1.548 0.1068 2800 16.02 120 2.322 0.1602 2900 21.36 160 3.096 0.2136 3000 26.7 200 3.87 0.267 3100 32.04 240 4.644 0.3204 3200 37.38 280 5.418 0.3738 3300 42.72 320 6.192 0.4272 3400 48.06 360 6.966 0.4806 3500 53.4 400 7.74 0.534 3600 58.74 440 8.514 0.5874 3700 64.08 480 9.288 0.6408 3800 69.42 520 10.062 0.6942 3900 74.76 560 10.836 0.7476 4000 80.1 600 11.61 0.801 4100 85.44 640 12.384 0.8544 4200 90.78 680 13.158 0.9078 4300 96.12 720 13.932 0.9612 4400 101.46 760 14.706 1.0146 4500 106.8 800 15.48 1.068 4600 112.14 840 16.254 1.1214 4700 117.48 880 17.028 1.1748 4800 122.82 920 17.802 1.2282 4900 128.16 960 18.576 1.2816 5000 For My96 I believe the max reading (Fuel Cut) is set at PSI Bar mv 15.48 1.068 4600 |
All times are GMT +1. The time now is 02:30 PM. |
© 2024 MH Sub I, LLC dba Internet Brands