3 port boost solenoid on std ecu???
Going for a remap soon with a JDM Hawkeye. Wondering if I should get a 3 port boost solenoid, it will be a remap on the oem ecu, can that work with 3 port solenoid ok?
|
Yes and yes.
|
Another post talks about the classic one being the best |
Originally Posted by 1509joe
(Post 12036981)
Yes and yes.
Originally Posted by RobsyUK
(Post 12036982)
Another post talks about the classic one being the best |
Originally Posted by Maverick424
(Post 12036986)
Thanks
As in the oem solenoid from a classic? |
Originally Posted by Maverick424
(Post 12036986)
Thanks
As in the oem solenoid from a classic? |
Go for the 3 port solenoid from scoobyworx, this was recommended by the mapper I used and it has been spot on.
|
Originally Posted by Lefty1
(Post 12037071)
Go for the 3 port solenoid from scoobyworx, this was recommended by the mapper I used and it has been spot on.
|
+1 for the scoobyworx 3 port bcs too (Y)
|
Got the Pierberg on mine been good as gold
|
Depending on how handy you are you can always buy one of these: Vacuum Solenoid as they are the same unit as the scoobyworkx one (I bought both, and they are the same apart from the mounting). You just need to make a flylead with some 2.8mm red spade connectors and electrical tape..... a little project and save some £'s :thumb:
|
Good find!
|
Originally Posted by BrownPantsRacing
(Post 12037195)
Good find!
|
All times are GMT +1. The time now is 02:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands