ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   Engine vibrating at idle (https://www.scoobynet.com/general-technical-10/1056149-engine-vibrating-at-idle.html)

mellinator2k 15 September 2018 08:50 PM

Engine vibrating at idle
 
Hi guys

I have an STI v3 and particularly when cold the car tends to have a slight vibration/judder on idle. This can be felt through the car when sitting at lights.
Car honestly drives great and is defo worst when cold.

Here are my findings so far

*The revs remain constant on idle - no major fluctuations
*The car has all the power expected - keeps up with my brothers 335i and 335d on spirited runs
*No smoke out of exhaust to be concerned out
*Spark plugs changed and properly gapped recently
*Timing belt changed before I got car (car has always idled this way since I got it)
*No engine management light or codes being displayed
* I will double check but does not happen every time the car is started


Any ideas on what I should target first as "quick wins"? Was thinking of replacing HT leads as they looks old - is there a way to test for faulty HT leads?

CharlySkunkWeed 15 September 2018 10:25 PM


Originally Posted by mellinator2k (Post 12026947)
Hi guys

I have an STI v3 and particularly when cold the car tends to have a slight vibration/judder on idle. This can be felt through the car when sitting at lights.
Car honestly drives great and is defo worst when cold.

Here are my findings so far

*The revs remain constant on idle - no major fluctuations
*The car has all the power expected - keeps up with my brothers 335i and 335d on spirited runs
*No smoke out of exhaust to be concerned out
*Spark plugs changed and properly gapped recently
*Timing belt changed before I got car (car has always idled this way since I got it)
*No engine management light or codes being displayed
* I will double check but does not happen every time the car is started


Any ideas on what I should target first as "quick wins"? Was thinking of replacing HT leads as they looks old - is there a way to test for faulty HT leads?

exhaust hangers ? It might be bouncing about just.

1509joe 15 September 2018 10:36 PM

Old spray bottle from under the sink, fill full of water and in the dark spray HT leads etc. If you do change them oem is the best but sort of expensive.

mellinator2k 16 September 2018 11:06 AM

Thnks mate. What would I be looking for when I spray the stuff on?
Thanks

1509joe 16 September 2018 04:57 PM

Sparks ;)

mellinator2k 16 September 2018 05:50 PM

Ha ha thanks

V-Lim Jim 16 September 2018 10:42 PM

My v3 sti had the same symptoms, predominantly a lumpy idle when hot or cold. This was even after a new short block had been fitted!

I have just replaced my lambda/o2 sensor and it has removed these symptoms completely, the car also doesn't fall flat on it's face between gears any more! The sensor was approx £200 from subaru.
https://cimg8.ibsrv.net/gimg/www.sco...c744f2ca41.jpg

mellinator2k 18 September 2018 07:07 PM

Thanks mate, will consider this if required

supshon 18 September 2018 07:29 PM


Originally Posted by mellinator2k (Post 12027347)
Thanks mate, will consider this if required

same sort of problem I just had with mine , checked the ecu and it read code 32 (lambda sensor ) , I think the sensor has a heater in it which can fail which makes it worse when engine is cold , got a genuine one off the shelf from a s performance for a nice price

mellinator2k 18 September 2018 08:32 PM

Thanks guys, weird thing is I had no engine management light come on at all. Did you guys have an engine management light come on?

supshon 18 September 2018 08:55 PM


Originally Posted by mellinator2k (Post 12027359)
Thanks guys, weird thing is I had no engine management light come on at all. Did you guys have an engine management light come on?

no engine management light for me only found out when I read the code

mellinator2k 18 September 2018 09:08 PM

What is easiest way to read codes on a 1997 v3 sti ?
This ? http://www.scoobypedia.co.uk/index.p...eadingECUCodes
Thanks

supshon 18 September 2018 09:47 PM


Originally Posted by mellinator2k (Post 12027364)
What is easiest way to read codes on a 1997 v3 sti ?
This ? http://www.scoobypedia.co.uk/index.p...eadingECUCodes
Thanks

that’s what I did , mines a v4

mellinator2k 18 September 2018 09:54 PM

top man thanks!

V-Lim Jim 18 September 2018 10:02 PM


Originally Posted by mellinator2k (Post 12027359)
Thanks guys, weird thing is I had no engine management light come on at all. Did you guys have an engine management light come on?

Yes I had a check engine light after about 12 months of ownership but it had done the vibrating thing from the start. code 32 for me too once the CEL started appearing


All times are GMT +1. The time now is 10:27 AM.


© 2024 MH Sub I, LLC dba Internet Brands