Rear bumper mount replacement
 

I made a silly mistake and reversed into a wall, fortunately I was going very slowly, but some repairs are of course required!

The bumper mount on the drivers side rear is now bent and needs replacing (might be possible to bend it back, but not worth the hassle of removing it all to find out it can't be), I've seen this item on ebay but it's for the GDB Link to eBay bumper mounts. I think my car is a GDA (2006 WRX). Can anyone tell me if it'll still fit? I assume so but I'm no expert and really don't want to have to remove the bumper (and ironically my reverse camera...) to find out!

I've put a red box around the rough area where the mount I'm looking to replace is:

https://cimg5.ibsrv.net/gimg/www.sco...b96aabd958.jpg

The item shown in your ebay link runs across the back of the car (item 6 below) not along the side as you have highlighted

http://static.opposedforces.com/epc_...1494959103.png


Looks as if you may need item 16 -Bracket-rear bumper side, right, 57717FE640

https://www.importcarparts.co.uk/par...y=&searchPart=

or even 10 or 22

Full parts list
http://opposedforces.com/parts/impre...llustration_2/

Super glad I asked now :)

Thank you so much for your help, that's great information