Strut Brace Bolt Torque?
I have just fitted a front top strut brace
The brace bar ends in the plate slots each end have a small amount of play ie the bar is not a snug fit What should I do with the bolts holding the brace bar ends in the tower plates - do I keep tightening it right up squashing the plates against the bar, or just moderately tighten it? The nut is a nyloc so it isn't going to come undone... The pic below is not my bar, but a stock pic I've linked, but it's the same design https://cimg4.ibsrv.net/gimg/www.sco...19fbdc6639.jpg |
Have to be tight otherwise its a pointless exercise.
|
Originally Posted by 1509joe
(Post 12010647)
Have to be tight otherwise its a pointless exercise.
|
Some had wee spacers. Sure there's not a hidden plastic bag in the box alternatively pack it out with some stainless washers.
|
Originally Posted by 1509joe
(Post 12010657)
Some had wee spacers. Sure there's not a hidden plastic bag in the box alternatively pack it out with some stainless washers.
I'll double check :) |
All times are GMT +1. The time now is 12:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands