|
1995 wrx misfire on 1 cylinder
Hi guys i have a 1995 wrx. Which has all of a sudden decided to develop a misfire on 1 cylinder. It seems like it is not getting enough voltage to the coil. It has a 12 v live all the coils do but the other pin in the plug that plugs into the coil (which i assune is a negative?) shows 2v on that particular coil but 10v on other coils. Does anybody have a wiring diagram of the idnition coil and how the ignition system is workkng on the 1995 wrx i understand they have a ignitor also. 5 pin entry plug and 4 pin exit pin which i assume is the wiring which goes straight to the coils? Has anybody experienced this before and any help would be appreciated thanks guys. |
http://www.ken-gilbert.com/wrx/mans/...996impreza.pdf
check out the Engine Electrical System diagrams |
Thank you
|
Have you checked for cracks under the rubber boot on the coil pack ?
|
Originally Posted by JDM_Stig
(Post 11985434)
Have you checked for cracks under the rubber boot on the coil pack ?
No I havent mate will do tomorow. I dont think its the coil but will try a coil off a diffrent cylinder to seenif the misfire is still on the same cylinder. Are they know for the ignitor to pack up? |
|
[QUOTE=JDM_Stig;11985448]does it still run something like this ?
http://napolperformance.com/media/ca...5/_/3/_321.jpg[/QUOTE hi after doing a few checks on it today it turns out it is 100% a faulty coil.Do you know where i could get 1 from |
euro stock them, but they are 140 quid,
as mentioned on the other thread, the conversion is a big improvement, and isnt complicated. |
| All times are GMT +1. The time now is 03:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands