Internal boot release on a spec c
 

Hey,

Has anyone had any experience with fitting a boot release inside a spec c. I know it's a simple thing but I'm getting bored with having to take the key out to open the boot (and I might have accidentally locked my keys in the boot and had to unbolt the rear seat to get at them once :oops:). I was thinking of fitting a cable so I can open it, where is the lever in a car that comes with it as standard? I have a 06 hawkeye.

Thanks for any thoughts!

strange it doesnt have one, where is the fuel filler release?
they are below drivers seat, in front of the right hand seat rail on most (jap cars) ive seen

Most parts are listed here

http://opposedforces.com/parts/impre...llustration_2/

The fuel filler release is down where described but there's no boot release. Maybe because it's spec c? Thanks Don, that picture is perfect. Are the fuel and boot releases on the same lever housing?

Looking at the picture again, I'm guessing cable 10 is for the fuel release?

That's what it says against item 10 ;) just scroll down the page

Missing info not on Opposedforces page (relevant for MY06)

Item 2 is "Knob Opener handle fuel" 57346AA010ML

Item 4 is "Tapping screw - truss Head M5" 904500027

Item13 is "Grommet sheet D30" 909230046

might be worth a call to one of the breakers, see if any are local to your location so you can pop back if anything is needed ?

Thanks for the missing bits Don. Yeah, that is a good idea about breakers, I'll get on that.

GradeA are often good. They did me a "kit" of used parts to convert my classic to rear wash-wipe.