Emissions Fail again :(
Hi all, I know there's been a lot of posts about emissions, so sorry for the repeat.
I had my WRX MOTed and it failed on emissions: Fast Idle Test CO- 1.02% vol (fail) HC- 51ppm (pass) Lambda- 0.988 (pass) 2nd Fast Idle Test CO- 0.60% vol (fail) HC- 523ppm (fail) Lambda- 1.365 (fail) Before this test, I had an error code- P1312 bank 1. After the test, I replaced the lambda sensor (but it was from eBay for £50 and I had to cut the wires to fit it). I also had the engine Terracleaned. I just had it re-tested and it failed again, with the same-ish results!! The car has been modified- it has an adjustable actuator, a Cosworth panel filter, has been retuned to 270bhp, a 3" Cobra 200 cell sports cat, a 3" mid section and a Nur spec back box. Any advice to get me through the MOT would be great, please. Thank you very much. |
20 quid in the ashtray
|
Originally Posted by RAGGY DOO
(Post 11939458)
20 quid in the ashtray
|
all so runs a bit rough /lumpy
|
Are all the exhaust joints done up tight
|
Originally Posted by dpb
(Post 11939471)
Are all the exhaust joints done up tight
|
Try the correct oem O2 sensor rather than a botched eBay special?
|
I never had to put my sti through MOT and had additions , totalled it before that , but
with xsara I have now the guy the garage put in generic lambda and spent hours getting it through emissions . I put recommended one this year and there wasn't a problem ( could all be incidental - they should last a Long time ) |
id also be checking out last years mot emissions
|
Originally Posted by dpb
(Post 11939484)
id also be checking out last years mot emissions
fast idle co-0.68 hc-46 lambda-1.005 2nd fast idle co-047 hc-36 lambda-1.034 |
I'm running a 2007 hawkeye and had to have a new (genuine) Lambda sensor fitted this year to get it through the emissions.
|
All times are GMT +1. The time now is 06:34 PM. |
© 2024 MH Sub I, LLC dba Internet Brands