Mapped hawkeye problems
So I took my car for a remap and it made 432 bhp on the dyno boosting 1.5 It was taken out for a road test and everything was fine.
after the car was giving back to me on the way home I did put my foot down and it felt very slow but I didn't think too much to it because I was behind a lot of traffic on the way home so couldn't test it again. Next day I took it back down the A1 and it was only boosting 0.9 ish , that the reason it felt slow also I had some features mapped to the ecu like blip and launch control. they also don't work any ideas as to what might have happened ? it's almost like standard with no map present ! |
Has it got twin maps?
If so is there any way you might have switched to a low boost map? |
Also,what's blip? ALS?
Is this and LC on a switch? |
Both should be same bhp but should be able to enable the the blip throttle and launch co trol as separate but they arnt working either
|
If it's like my map try driving in 6th gear, floor the throttle and press the rear de-mister switch (all at the same time) . This changes the map on my car to a lower boost setting.
|
Might be worth a quick call to the mapper to ask ?
|
is 0.9 not just actuator pressure ?
|
It might well be ...
I'm bk to mapper Wednesday they are very helpful . was just wondering thought if anyone had something like this happen to them after mapping as I've haven't done anything and seems wired as they brought car bk saying it was fast !? |
if it's only boosting 0.9 it sounds like it's in limp mode, have the mapper check and confirm this could be a wee hose has popped off or something silly just.
|
All times are GMT +1. The time now is 09:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands