caliper retaining clip
 

hi does anyone know witch way round the retaining clip on the brembos go I think I may have fitted them upside down im getting a clicking noise when pressing the brake on one side

does this help ?

https://cimg7.ibsrv.net/gimg/www.sco...138b342753.gif

thanks mate I was after witch way up the little pin clips go I , they have a flat side and then a curved side I think curved side is suppose to point up on both but not sure

This ?
https://cimg4.ibsrv.net/gimg/www.sco...8a04baadfe.jpg

Google is great lol

yer thanks mate it looks like they both face down would you agree

They just push in with the lug to the centre and in the groove.

checked all my brakes today and the clicking is still there you have to start pushing hard then starts creaking its coming from drivers side maybe master cylinder has anyone had this before

If it sounds like its down at your feet lubricate the pedal linkage, regular problem. Spray grease is the handiest.

ok just spray all joints from the brake pedal with wd , been reading that could need to clean the pistons out or remove those angled shims has anyone done that , pads did have shims stuck to back them any way

Do one thing at a time fella or you'll end up chasing your tail ;)