Blobeye Angel Eyes - Halo wiring help
Hi all,
First post having just picked up my first ever Scooby. It's a 2005 WRX. I've picked up a pair of Angel Eye headlight replacements and fitted them yesterday, but I can't get the halo rings to work. All the other lights are fine. The instructions that came with them are cr@p, and I spent all of last night searching online for help but came up with nothing. There is a set of black & white wires running from each of the halos, which run into a small 'box' and then come out as a single set of wires. My understanding is that I need to wire these up to the ground and side-light wiring loom. This has 3 wires running into it: White/Red Black Green/Black I used a multimeter to check the wiring loom, and initially I believed that this was the mapping: White/Red - indicator Black - ground Green/Black - sidelight I then used a clamp to run some extra bits of wire from the loom to connect up to the halos: White - sidelight Black - ground When I switched on, nothing happenned... (The LED sidelights came on, but not the halos). To try and rule it out, I then tried swapping the Green/Black on the loom with the Red/White, which is what you can see below (although I subsequently appreciate that probably wouldn't have made a difference...) https://cimg6.ibsrv.net/gimg/www.sco...133597b9b.jpeg https://cimg8.ibsrv.net/gimg/www.sco...18a1cd6c6.jpeg https://cimg1.ibsrv.net/gimg/www.sco...f7bddf714.jpeg So my question is, has anyone else installed these, and if so how did you wire the halos? Thanks in advance, Will |
You may have to run a cable from the sidelights to make them work.
Sadly Will the performance on Subaru headlights is poor. You have made it worse. They look good but a good Maglite torch will perform better. |
All times are GMT +1. The time now is 03:29 AM. |
© 2024 MH Sub I, LLC dba Internet Brands