Carbon Bonet Warped?
 

Just fitted a carbon bonet and sits nicely front and rear but has a gap down either side.
There is nothing in the bay pushing up so can only assume either poorly moulded or warped.
Been reading possible solutions and wondered if panel pins installed down the side could be a solution.
Basically looking for ideas/solutions.
Have mailed the retailer pics but would rather try and fix.
https://www.sugarsync.com/pf/D2438570_359_770413896
https://www.sugarsync.com/pf/D2438570_359_770413445

was it new? If so, it was probably costly and have some sort of guarantee with , so why should you try to fix it? If you try , and fail , to fix it, the vendor wont to know. Return it