rob84 |
26 July 2015 06:44 PM |
Fairly easy, Just need to remove the lamps from the car and strip them down and remove the screws on the casing. pre heat the oven to 100c then pop the lamp in for 10 mins and pull them apart, at this point you need to remove the chrome trims and affix the halos to the bezel, two options small drill holes approx. 1mm and fix them with very thin tie wire or the second option I did was affix them with clear epoxy resin making sure it cant be seen, then drill a hole in the chrome at the base under the halo to run the wires out of the rear of the lamps. I then ran them as drl's so used an Audi style controller for them
|