Armourfend have recently installed their protective film on the front of my Scoob. After installation I noticed some bubbles between the film and the bodywork. I rang Armourfend they said these bubbles will disappear after about 3 days. This was 5 days ago. Has anyone had any experience with this protective film, and more importantly do these bubbles disappear?

Am I being paranoid?- HOPE SO!

Rasher

Sounds to me like they made a sh1t of putting it on - where is the air going to go if its trapped under the plastic. You could try pin pricking the bubbles and pressing them out but at the price I expect you paid I'd want them to do it again.

Rasher

I'am looking to get MY02 WRX done how much did it cost you???

Dave.

I've got a couple of bubbles under the bonnet piece on my Sti7 they did 2 weeks ago, not really bothered but next time i'm near them i will get them to have a look.

simon

X8 DMB,
I paid about 400 quid for , the front spoiler, bonnet, section below the inter cooler, wing ends, wing mirrors,front grill, rear bumper section and labour .
I rang Armourfend, they said that all they would do was prick the bubbles with an insulin needle to drain off the fluid. but they would not be up in my area for a while so suggested I do it, which I probably will.
Know any diabetics

Rasher.