Wanted - dump valve blanking plates?
 

As above im after a blanking plate for the OEM recirc valve

Just make one make a template the rear of valve cut sheet metal drill holes then just screw recirc back on

Good plan. What thickness in mm you think? 5mm-10mm?

I used 10mm

Leave gasket attached to help seal

Cheers bud. Where you get the metal from?

Mechanic had it mate

send a pm to scoobynet member white noise as he makes these

10mm is a bit hardcore, Peter. :eek:

3mm alloy will suffice, couple of quid for a small enough plate on ebay.

He just used what he had laying about mate

Cheers shrek, sam said that he can supply them!

And ive found 10mm thick ally on ebay for 9 quid! Need to find something decent to cut it? Jigsaw maybe with a ally blade?

10mm is overkill and not needed that thick lol ,, Ill make you one if you want mate iv got a couple made but not 100% where they are at the mo lol , would drive loads better with a recirc on though

You also need a bung. ;)

I never used a bung i left recirc attached to hose and put blanking plate on tmic and screwed recirc back into place

That's certainly one way of doing it. :thumb:

How well did it work?

Perfect no leaks