Unused lateral built CDB 2.1
 

Here's my unused Cdb 2.1 built up by lateral performance it,s complete with Rcm baffle plate, 11mm oil pump new water pump sump and oil pick up pipe new moodiness and coolant pipe also it will come with gates Kevlar belt head gaskets and main others new rolls fir belt and a brand new set of arp head studs spent over £3500 on this lot easily , looking for £2500 plus charges and shipping if needed
http://i96.photobucket.com/albums/l1...magejpg1-3.jpg

Also
supertech valves ,double valve springs,titanium retainers and guides SOLD
newage Brian crower vernier pulleys £300
Cs400 3 bolt exhaust manifold and up pipe almost new condition £300
All plus charges and shipping

Where you based?

Crawley

what pistons and rods were used please?

http://i96.photobucket.com/albums/l1...magejpg1-4.jpg
http://i96.photobucket.com/albums/l1...magejpg2-1.jpg
http://i96.photobucket.com/albums/l1.../imagejpg3.jpg

Hope that's answer your question :D

Photo quality isn't great

It says lateral/Wiseco pistons and lateral rods

Any pics of the supertech sutff?

Hi what power would this block handle, and would my 2.5 avcs heads fit straight on?
Ta

Supertech valve train parts sold to me :)

See you Tuesday

As far as I know you will need to have 2.5 heads machined to fit 2.0 blocks, you can do it the other way around though.

We'll I think lateral have seen well over 500hp with this block and internals , best person to speak to about 2.5 heads and this bottom end setup would be lateral themselves but would think it would be just a case of different head gaskets to get correct CR

Morning bump

Keep looking at this I'm very tempted I'm only down the road

Why don't you come and have a look :)

99% of the parts needed to swap over the bottom end are included in the deal

Met Toby tonight for some bits. Nice guy and the engine is bang on. Someone's gonna get a nice early Xmas prezzie.

Nice meeting you Matt !! and good luck with racing that beast of a car of yours :)

What's your number mate

Pm sent :norty:

Vernier pulleys, will they fit on a V5/V6

Yes they will fit but not sure if cam pulley pick ups for the sensor are right for v5/6 as they are newage units which maybe different ???

Did u get my txt mate

Nope !!!
Send me a message with you number and I'll text you now

up!!

DEPOSIT TAKEN ON 2.1 STROKER