ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   ScoobyNet General (https://www.scoobynet.com/scoobynet-general-1/)
-   -   emmisions results (https://www.scoobynet.com/scoobynet-general-1/1005296-emmisions-results.html)

dj219957 31 May 2014 12:45 PM

emmisions results
 
Hi everyone, could you please help me:

my 94 wrx has failed its mot on emissions. results below.
its failed on the c0.

could it be
- bad lamda?
- bad cat?
- exhaust leak?
- cat not hot enough? (every garage I ask to test at 3.5% says they have to use .3% as has this one - they would not even take it out for a longer run to get the cat super hot!

im going to take it else where but could do with some advise on the readings please.


fast idle test

co 0.95% fail
hc 66ppm pass
lambda 0.99 pass

second fast idle test

co 1.08% fail
hc 55ppm pass
lambda 0.97 pass

natural idle
co 2.33 fail

Turbotits 31 May 2014 07:45 PM

CO is more than likely a cat issue. Was the cat hot when the car was tested?

dj219957 31 May 2014 07:50 PM

hi, the car has been stood for 18 months, I drove it across town as hard as I could to get some heat into it. it was then left for 25 mins before they tested it. I had to leave it with them so I have no idea if they gave it a run first but when questioned they said the car was up to temperature as per any other car they test.

dj219957 31 May 2014 07:52 PM

suspect I may have to book another test a bit further away from home maybe? its difficult cos its not taxed or mot at the mo which makes getting it warm before a test difficult.

stedee 31 May 2014 09:39 PM

Find a decent tester and tell him what's up.

dj219957 05 June 2014 07:39 PM

bit of an update:
I tested the output voltage of the lambda sensor with the engine warm and idling and it was stuck at around 0.4 volts. so ive fitted a new lambda but its the same. it will flick up and down between 0.1 and 0.9volts if I rev the engine but it wont cycle at idle.
I suspect the car is not dropping into closed loop? why would this be? coolant sensor maybe?

bighead 05 June 2014 11:01 PM

you just need a "friendly" M.O.T tester ...that all :D

Derby1971 06 June 2014 10:41 AM

1 Attachment(s)
Hi,
I had the same problem at my mot for a 95 WRX RA. I found this pic on a similar post, printed it out and took it back. They passed it straight away. Depending on the year of manufacture the import won't need a cat test if they can't find the exact model on the database. Might help you a little.

dj219957 07 June 2014 06:51 PM

the universal lambda for £17 and some drop links for £13 off ebay have done the trick - shes passed! also took that BET info down too and they were alright with it.

Derby1971 07 June 2014 11:10 PM

Well done, you can relax for 11.5 months now!


All times are GMT +1. The time now is 03:16 PM.


© 2024 MH Sub I, LLC dba Internet Brands