Clifford Concept 600 - siren not working?
 

Hi all,

When i lock/unlock my indicators flash without any chirps, when i set the alarm off the indicators flash but no chirps.
I tried to see if it was in silent mode but it was as if the programming was doing nothing (no chirps, no indicator flashes, nothing)

The siren went off once when the 12v car battery was about to die and it has never been heard since.

Could this be a new siren needed issue? Or just change the master fob battery?

Thank you for any advice,

Doubt it is the fob. If the siren doesn't sound when the alarm goes, would point to siren fault (or wiring...)

I would think that the battery pack inside the siren needs replacing. I had same issue with my Concept 500 although I think alarm sounded if I made it go off, just no chirps when arming and disarming. You can't get the battery pack separately from Clifford or a dealer, you have to replace the whole siren. I did manage to get my battery pack replaced though by a guy who advertised new packs he built himself using much better spec batts than the originals. He also fitted it, based in Birmingham so a bit far from you.

https://www.scoobynet.com/security-1...-chirping.html

I found a business card for the bloke = Midland Auto Alarms on 01384 263326 if still correct.

Steve at midland auto alarm also gets my vote! Sorted all my issues with my sigma :thumb:

Thanks guys.
I see there are sirens on ebay so may just get one, do you know if they are juat unplug and plug or do you have to rewire it all in?

Have u got 2 button fob if so push the small button which is panic and if alarms goes off then its fine just need to program chips and i turned mi e off .

2 buttom fob no. Have one with 5 on and another with 4 which is the companion one.