Potential ESL tuning glitch?
Today I decided to tweak my boost levels a bit to achieve a smoother curve and I came across something interesting that I'd like to see if others have experienced.
While changing boost values in the Boost Target window I noticed that the ESL software would disconnect after I attempted to change a value. The square where I altered a value remained pink (which appears to be the processing value colour before it's actually applied). However after the ECU disconnected (on its own) I was unable to reconnect, at this point I have to reload ESL. Upon loading ESL and reading the ECU again the value I attempted to change did not take, so I tried again only to have the value not take and the ECU disconnect. I tried this multiple ways, car running, only ignition on. Also I'd like to mention that a few other values that I had changed previously did take and were loaded to the ECU no problem. Any ideas? Software glitch? Anyone else experience this? Andy? |
double post
|
Sounds like you have some noise on your rx/tx or gnd lines, is your loom modified?
Switch connection type; Connection-Connection Type-Current Map, that should help clean it up. Be sure to always start a new session on changing maps. If you are after support, best to email service@enduringsolutions.com as I may not always see it on a forum. Cheers. |
All times are GMT +1. The time now is 06:24 AM. |
© 2024 MH Sub I, LLC dba Internet Brands