When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Interesting bulbs Phil, how do these compare to std main beam - I swapped to Osram nightbreakers but they are quite yellow and not sure if much better than std.
Which fitting - HB3 ? and does it need to be canbus type?? ( don't think so ). Is the base angled and have the plug for the loom?
There are some uprated D2S bulbs for the main beam out there.
Autobulbsdirect.co.uk have a good range and Black Friday offers on now.
Interesting bulbs Phil, how do these compare to std main beam - I swapped to Osram nightbreakers but they are quite yellow and not sure if much better than std.
Which fitting - HB3 ? and does it need to be canbus type?? ( don't think so ). Is the base angled and have the plug for the loom?
There are some uprated D2S bulbs for the main beam out there.
Autobulbsdirect.co.uk have a good range and Black Friday offers on now.
hatches dont use d2s on main beam though? its just standard HB3 bulb, its the dipped beam which is d2s hid bulb.
I've got ds2 for dipped, Nightbreakers, quite expensive, an improvement over oem but not stunning. I've got main beam hid Nightbreakers and they are a great improvement, and £24 vs £60 odd for dipped, all for jdm car
Been having problems on and off with air con every few months for last 2 or more years.
Been into air con "specialists" and main dealer. Changed high and low port valves and some O rings. Compressor quite noisy.
Seems to lose gas over 3 months ish, and this last time inside a month.
Today was misting up inside car, air con on but doing nothing .. checked - ZERO pressure in system. Regassed with leak stopper and 1 x 450g can refrigerant. Compressor started up - on, off, OK. Then came on, stayed on, pipes in and out compressor REALLY hot - water boiled off them! and high pressure port plastic cap had melted threads!
While watching this ..... WHoosh, cloud of oil and fridge gas came out of n/s compressor body - looks like blown compressor gasket??
Apparently had smelt "oily" for a while in the cabin!
SO, any one got a spare WRX STi 2009 330S air con compressor going cheap? Found a recon one on ebay. Any other parts I would need - O rings for high and low pressure pipes?
I had Ac issues, went to a ac specialist who found a leak on the 'O' ring... after Neon die was put through the system.
came home, still same issue and they said it must be the compressor.
took it to a main dealer as was under warranty, they tested it, said 'O' ring had a leak!!!!
They swapped it to find wrong 'O' ring was used, they fitted new one. worked.
I have had new compressor the other year (out of warranty) as it had a hole in the fin. cost about £400 fitted.
2 times ago at dealers they could not find anything wrong, refilled it but had emptied mainly in a few months.
Used local place just for refill twice - no leaks but finally thought it was the port valves
Next time at dealer had ordered in port valves and O rings ( think for hose connection to compressor ) but dealer "did not have the tool to fit the valves" !!
So back to local company for another refill AND fit the valves / o rings.
Lasted 6 months?
Never any sign of the fluorescent dye from leaks, holds pressure in their vac / nitrogen pressure tests prior to refilling, so bit of an odd one.
This year had to fill couple of times and used a sealer last 2 times, lasting 2-3 months then 1 month ... and then today seemed to work well but blew seal on compressor a few minutes later! Pipes were very hot... I think compressor has been running when empty and overheated - cap off high pressure port had melted threads, and water on the hose fitting at compressor boiled!
Any idea where the pressure switch is - compressor? as it's supposed to stop running with low pressure / no gas AND over pressure ..... don't want to change compressor and not that vale!
I can change either just compressor and hose o-rings, or as suggested in that USA link front air con radiator/drier, expansion valve and compressor.
Not sure how to get out the front air con rad with FMIC etc.!
AFAIK the TRIPLE pressure switch only supplied by Subaru as part of the low pressure pipework (highlighted in yellow)
"Pipe - evaporator cooling" part number 73431FG000
If you can read the label it is manufactured by Denso
High pressure switch turns the compressor (magnet clutch) to OFF when the refrigerant pressure becomes extremely high to prevent the evaporator, air conditioner piping and expansion valve from getting damaged or frozen.
Middle pressure switch effectively controls the radiator fan output by judging high load/low load in normal range.
Low pressure switch turns the compressor (magnet clutch) to OFF, judging as low refrigerant level when the refrigerant pressure becomes extremely low, to prevent the possible seizure if the compressor rotates.
Last edited by Don Clark; 28 November 2018 at 08:39 AM.
Has anyone removed the avcs banjo bolt screens on their hatch? Typically there is another of mixed info on this on the net, so it would be great if someone has already done this. Thanks
Has anyone removed the avcs banjo bolt screens on their hatch? Typically there is another of mixed info on this on the net, so it would be great if someone has already done this. Thanks
Leave them alone if your doing regular oil changes,on std or lightly modded engines.
Leave them alone if your doing regular oil changes,on std or lightly modded engines.
I've changed oil every 3000 to 5000 miles, but after the last 3 changes, I've had a lumpy tickover; you mentioned in an earlier post that the avcs does this after an oil change sometimes, so I was heading in that direction.
I've changed oil every 3000 to 5000 miles, but after the last 3 changes, I've had a lumpy tickover; you mentioned in an earlier post that the avcs does this after an oil change sometimes, so I was heading in that direction.
Does the idling issue go away once its been in gear & used up the road ?
Does the idling issue go away once its been in gear & used up the road ?
No, it`s worst after an oil change, it`s not enough to show on the rev counter, but the boost gauge flickers, more like a murmour. When hot, driver`s side has a hollow tapping at idle.
No, it`s worst after an oil change, it`s not enough to show on the rev counter, but the boost gauge flickers, more like a murmour. When hot, driver`s side has a hollow tapping at idle.
You need to read the live data on what's happening avc's wise, especially the exhaust side, they tend to be more sensitive than the inlet, the filters in them are in the alloy body bolted the the heads, & at times move backwards out of place, & can throw up issues.
No, it`s worst after an oil change, it`s not enough to show on the rev counter, but the boost gauge flickers, more like a murmour. When hot, driver`s side has a hollow tapping at idle.
scrap that yellow heap it’s almost as reliable as mine lol
Can anyone recommend a rear strut brace that fits over the boot carpet for a wrx hatch please ?. I’m assuming most sti/wrx rear strut braces fit on both models.
I am thinking of buying the Cosworth one and purchasing the crankshaft seal separately as that's the only difference between the Cosworth and the OEM one.
Ripped off .... lost wheels and new tyres at Foundry Alloys, Widnes
Well, that was an epic fail.
Dropped wheels with new tyres off at Foundry Alloys, Widnes, for refurb and probably colour change. The man there, Kyle, swapped the car over to the winter wheels/tyres and kept the 330S wheels with F1's. 21 Nov 18. Would be done in a couple of days.
No contact with them since then despite trying every other day and visiting unit - closed up - tried e-mail, phone, mobile ( 2 numbers ) voice mail, twitter and facebook to the business pages etc. and NO response.
Unit adjacent said he thought they had packed in the business, site landlord was unaware but had not seen them there a few weeks.
Visited site today, unit is open and NOW find the unit empty of equipment and wheels just a load of waste tyres and paint cans ... my wheels have gone ...
So I am out a set of 330S 18" wheels and new Goodyear F1's .........
Any thoughts - been to citizen advice, have written to the home address of trader... awaiting any response before I can go to trading standards or small claims court.
Great christmas present.....
Originally Posted by vulnax999
Std 330S wheels dropped off today for refurb.
What colour do you guys think would go well with the Dark Grey Metallic car? Thinking flat black? Or car body colour??
If anyone sees advert for 4 330S wheels with F1 tyres, in North West / Widnes area can you post here!
I
Originally Posted by vulnax999
Well, that was an epic fail.
Dropped wheels with new tyres off at Foundry Alloys, Widnes, for refurb and probably colour change. The man there, Kyle, swapped the car over to the winter wheels/tyres and kept the 330S wheels with F1's. 21 Nov 18. Would be done in a couple of days.
No contact with them since then despite trying every other day and visiting unit - closed up - tried e-mail, phone, mobile ( 2 numbers ) voice mail, twitter and facebook to the business pages etc. and NO response.
Unit adjacent said he thought they had packed in the business, site landlord was unaware but had not seen them there a few weeks.
Visited site today, unit is open and NOW find the unit empty of equipment and wheels just a load of waste tyres and paint cans ... my wheels have gone ...
So I am out a set of 330S 18" wheels and new Goodyear F1's .........
Any thoughts - been to citizen advice, have written to the home address of trader... awaiting any response before I can go to trading standards or small claims court.
Funny, when you inform them at every address known, that you will be taking legal action if they are not returned, 4 hours later get a reply about health issues so closed business and wheels/tyres are in the back garden come get them after returning from holiday Sunday!!
Didn't want to "send the boys round" as you know who'd be in the wrong with the police..... and he's bigger than me!
years ago brother put down a 10k deposit on an r32 gtr supposed be 800 bhp
months later all excuses still no sign of the car
he was reluctant to give the deposit back
so a car load of us went down
still no money so the brother said I’ll take the keys of that a white 1997 type r civic worth over 20k at the time
few days later he phones he has the money
low life’s like this are pond scum
i always wondered what would of happened if it kicked off
he had a few blokes with him
we had a boot full of hammers and slash hooks no ****
23 November 2018, 11:33 AM
Ripped off .... lost wheels and new tyres at Foundry Alloys, Widnes
and he's bigger than me!
