ScoobyNet.com - Subaru Enthusiast Forum - View Profile: Shaun

Notices

Shaun Shaun is offline

1st - ScoobySprint Final

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. Shaun
    08 April 2009 11:54 PM
    Personally I do not rate any top mount over the standard STI one. I suspect if you ran again you should see the power increase as the heat soak may of damaged your top end power figures. The peak torque figure suggests you are reaching good boost initially, but it looks like it is being knocked back at higher RPM. Could be down to heatsoak mate. Re-run again and see what you get... also get the boost plotted on the graph and I can see better what is going on.
  2. rickya
    08 April 2009 09:33 PM
    What went wrong!!
    I went to Lichos today & had following:
    Service; Prodrive 3 port boost; Forge 1.4 bar actuator;
    Last week I fitted full H&S 3" decat system with jap style angled exit; heat wrapped. Also have K&N air filter & Hyperflow topmount.

    Then after Lichos went onto Powerstation rollers with Rich mapping. For 1.5 hours we couldnt get decent figures & engine pinking with a little det (& upto -10 degress retarding). Rich though contaminated Vpower so we drained fue & I filled up again with Vpower. This time no det & +7 degress advancing.
    But after a further 1 hour only managed 340bhp with 370 ft/lb torque



    What do you reckon Shaun? Im confused & a little dissapointed. Not sure what to do next. I was hoping for 360bhp plus.

About Me

Statistics

Total Posts
Albums
Visitor Messages
General Information
  • Join Date: 02 March 2000
  • Referrals: 2

Friends

Showing Friends 1 to 6 of 6