blobeye clocks into bugeye now got ABS and Parking brake light on permanently
#1
Scooby Regular
Thread Starter
Join Date: Sep 2007
Location: wigston, Leicestershire.
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
blobeye clocks into bugeye now got ABS and Parking brake light on permanently
my fuel gauge was faulty in my 2001 Bugeye WRX so I have bought a set of Blobeye clocks from the net. the clocks are visibly different as in the speedo is on the right now but i was assured they will fit and work fine. the problem is that now I have fitted them the ABS and Handbrake light are permanently on with or without the handbrake on.
has anyone else found this and has anyone fixed this. I want to avoid putting tape over the light really if i can?
any help will be appreciated.
Mick
has anyone else found this and has anyone fixed this. I want to avoid putting tape over the light really if i can?
any help will be appreciated.
Mick
#4
Scooby Regular
Thread Starter
Join Date: Sep 2007
Location: wigston, Leicestershire.
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
I have searched but no look, what should i search for ive tried most combinations of 'bugeye to blobeye clock swap abs light' to no avail
Trending Topics
#9
Scooby Regular
Thread Starter
Join Date: Sep 2007
Location: wigston, Leicestershire.
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Thank you ive been searching for hours with no luck, it hadnt occured to me this would be common with sti-wrx guage swap, ive been clearly seachimg wrong. I will have a go at the weekend
editted: to add the howto for anyone searching who find this thread·
First of all Locate wire B3 and cut leaving enough wire on either end. Next you need a 5 pin change over relay connect as follows term 85 any ignition live 86 cut wire from loom 30 earth 87a cut wire from clocks This only works when fitting later clocks lo early cars and abs light is off when ign first turned on then after 2 or 3 secs it comes on and stays on. If you have problems with handbrake light term A2 needs an earth to turn off diff temp light B4 needs an earth.
editted: to add the howto for anyone searching who find this thread·
First of all Locate wire B3 and cut leaving enough wire on either end. Next you need a 5 pin change over relay connect as follows term 85 any ignition live 86 cut wire from loom 30 earth 87a cut wire from clocks This only works when fitting later clocks lo early cars and abs light is off when ign first turned on then after 2 or 3 secs it comes on and stays on. If you have problems with handbrake light term A2 needs an earth to turn off diff temp light B4 needs an earth.
Last edited by benmic92; 02 March 2012 at 12:48 AM.
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
MH-Racing
Subaru Parts
3
23 October 2015 10:18 PM