hole in bulkhead for amp power cables
#1
Scooby Regular
Thread Starter
Join Date: Mar 2001
Location: Berkshire
Posts: 5,528
Likes: 0
Received 0 Likes
on
0 Posts
anyone know if there is a hole in the bulkhead of the my01 wrx (with a rubber gromet in) so that you can feed the amp power cables thru ??
if not or not sure, is there another way ?
if not or not sure, is there another way ?
#2
BANNED
Join Date: Jan 2001
Location: In my own little world
Posts: 9,644
Likes: 0
Received 0 Likes
on
0 Posts
It a Bugger this one!!!!!
Would not advice drilling as there is so much electrics and stuff plus double walls.
On my legacy I found one by the Brake servo.
Think same on Impreza
Sure Chiark will know
Would not advice drilling as there is so much electrics and stuff plus double walls.
On my legacy I found one by the Brake servo.
Think same on Impreza
Sure Chiark will know
#4
On the MY98-MY00 there's a big grommet that's used for air conditioning in the passenger foot well. Make a small slit very near the centre, then use some stiff wire as a "feed". Attach your power cable, put a bit of WD40 on it then pull through.
#5
Yeah , use the Air conditioning grommet ,(BUT MAKE SURE YOU PUT THE A/C HOSE BACK THROUGH THE GROMMET) , the hose has only got to act as a drain , so if it squishes it slightly , it won't matter , but don't block it completely.
Nate
Nate
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM