when remap my early classic impreza t will I need a later map sensor to run 25psi?
#1
when remap my early classic impreza t will I need a later map sensor to run 25psi?
When get my early claasic Impreza turbo remapped on a link ecu, will be running around 25psi, would I be right in saying will need the later map sensor? If so, straight swap or need another connector to fit harness etc?
And where to buy one/parts?
Cheers
And where to buy one/parts?
Cheers
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
The Link ecu doesn't allow calibration of anything other than original map sensor or the GM 3bar map sensor..
Your original map sensor assuming it is a 98 car will read to 1.55bar and should be fine, although getting to the top of its range.
Simon
Your original map sensor assuming it is a 98 car will read to 1.55bar and should be fine, although getting to the top of its range.
Simon
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM